Clever Choice HD Manual do Proprietário descarregar pdf (Página 9)

Press the “S” button to select “On”, then to set the hour. When

the hour is flashing, press the “M” button to add an hour. When

the correct hour is set, press the “S” button to confirm and go to

set the minutes. Press the “M” button to add one minute. When

the correct minute is set, press the S button to confirm and go

to the next alarm setting.

If you want to turn off an alarm, press the S button to find the

right alarm number and press the M button to change from “O

n”

to “OFF”.

The date, time and memory deletion can ONLY be set in the

setting mode. When the meter is in setting mode, if no button is

pressed within 3 minutes, the meter will turn off.

THE TWO MEASURING MODES

The meter provides you with two modes for measuring, General

and CTL. The CTL mode should be used when a control solution

is being tested. See the table below.

CTL testing with the control solution

You can switch between each mode by:

1. Start with the meter turned off. Insert a test

strip to turn on the meter, the screen will dis-

play a flashing blood drop.

2. Press M to select General or CTL mode.

TESTING WITH BLOOD SAMPLE

To reduce the chances of infection:

● Choose a clean, dry work surface.

●

● Always use a new and sterile lancet. Lancets are for single

use only.

●

● Avoid getting lotion、oils、dirt or debris in or on the lancet

and lancing device.

Note: Before testing, please read the following steps thoroughly

and carefully, please relax and do the test step by step. Simplif-

ying or changing the test procedure may produce inaccurate

results.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Sem comentários

Clever Choice HD Manual do Proprietário Página 9